Theta 107 HT...
Back to Home
Grease5 min readDiperbarui: 16 Mei 2026

Lubrication Interval Guide: When Should You Pump New Grease?

How to calculate re-greasing schedules based on RPM, machine load temperature, and the dangers of over-greasing industrial bearings.

No matter how high-quality the lubricant you purchase (such as Molybdenum high-temperature grease), your machinery will still fail if the lubrication interval is incorrect. Most factories still apply a "one size fits all" schedule (e.g., pumping grease 10 times every Monday). However, a bearing rotating at 3000 RPM clearly has different needs than a roller rolling at 50 RPM.

What Are the Consequences of Over-Greasing?

Ironically, over-greasing is the number one cause of industrial bearing failure worldwide, exceeding back-of-the-envelope calculations for under-greasing.

  • Drastic Temperature Increase: Excess grease undergoes internal 'churning' (agitation), creating fluid friction that raises bearing temperatures beyond safe limits.
  • Blowing Out Bearing Seals: Pressure from a mechanical grease gun can reach 10,000 PSI! This pressure will rupture the bearing's protective seal (seal blowout), allowing industrial dust or water to contaminate the steel balls.
  • Extreme Waste: Grease spilling onto the floor not only wastes your spare parts budget but also endangers worker safety.

Multiplier Factors in Interval Calculation (Basic Formula)

Engineers use complex formulas based on C/P ratios and standard machine hours. However, practically, if your base frequency (for example) is pumping conveyor bearings every 6 months, you must reduce the interval (shorten the schedule) if you encounter these 4 conditions:

External Environmental ConditionFrequency Reduction
Extreme Temperature (Above 70°C, e.g., kiln / boiler)Cycle cut by 50% for every 15°C increase
Moderate to High Dust Contamination (Crushing Area)Cycle cut by 20% to 50%
Water Spray or High HumidityCycle cut by 50%
Shock Loads (Constant Vibration/Heavy Shock Loads)Cycle cut by 50%

Manual Grease Gun VS Centralized Lubrication System (Automatic System)

If your palm oil mill or manufacturing facility is exhausted by manual labor, an Automatic Centralized Lubrication System (Auto Lube) can inject 1 gram of fresh grease every hour, as opposed to manual maintenance where a worker injects 20 grams per month.

The golden principle: "A little but often" is far more ideal for your bearing's metallic life than "Much but Seldom".

Have Specific Questions?

Our team of engineers is ready to help provide specific guidance for your agricultural, manufacturing, and palm oil machinery needs.

Contact Our Experts